Skip to product information

No Tipper Bottle Supporter

$13.54 $14.24
SKU: HS0001
Free Shipping on all MPM Hobbies’ 3D Printed Products

3D Print Product Info

  1. Item(s) is/are LCD-based SLA printed using UV cured resin and will be shipped unpainted and with 3D print supports attached.
  2. All items receive a 20 min wash cycle with 2 ten-minute sonic wash cycles followed by a 2-to-8-minute cure. 
  3. Item can be primed with acrylic, lacquer or enamel type paint. Lightly sand and/or prime any horizontal striations due to the printing process.
  4. Remove supports starting from the tip down and start by freeing those supports connected to small and fragile details.
  5. Recommend using CA for attaching item to model or filling any imperfections.
  6. Item(s) will have features that are brittle or extremely delicate and prone to breaking if not properly handled.
  7. 3D print support configurations may be different than the ones in the photos if applicable.
  8. Photos may include the CAD rendered file used for printing to highlight details that do not stand out well in regular photos.
  9. Not intended for small children due to choking hazard and should only be purchased by experienced modelers due fine details and printer support removal.
  10. The number of items in your order is calculated by multiplying the quantity you selected by the number of items per set if applicable.
  11. The small holes on the print are necessary to drain the hollow parts of the item of leftover resin.  Fill hole with CA and sand. 

"Tired of knocking over bottles and spilling harmful chemicals all over your hobby desk or table? If so, then you need a No Tipper! Simply put that bottle in the No Tipper and give yourself a little more protection against those spills. The No Tipper 55 is 55mm in diameter, 3mm thick, 50mm deep with a base spread of 140mm. Put an end to messes and unnecessary exposures to harmful chemicals, buy the No Tipper. It works better than a 2x4 with a hole in it, trust me.