1/48 AN-M41 with M-1 Series Cluster Adapter (Set of 4)
1/48 AN-M41 with M-1 Series Cluster Adapter (Set of 4)
1/48 AN-M41 with M-1 Series Cluster Adapter (Set of 4)
1/48 AN-M41 with M-1 Series Cluster Adapter (Set of 4)
1/48 AN-M41 with M-1 Series Cluster Adapter (Set of 4)
1/48 AN-M41 with M-1 Series Cluster Adapter (Set of 4)
1/48 AN-M41 with M-1 Series Cluster Adapter (Set of 4)

1/48 AN-M41 with M-1 Series Cluster Adapter (Set of 4)

$11.83 $15.89
SKU: 0123
Free Shipping on all MPM Hobbies’ 3D Printed Products

3D Print Product Info
  1. Item(s) is/are LCD-based SLA printed using UV cured resin and will be shipped unpainted and with 3D print supports attached.
  2. All items receive a 20 min wash cycle with 2 ten-minute sonic wash cycles followed by a 2-to-8-minute cure. 
  3. Item can be primed with acrylic, lacquer or enamel type paint. Lightly sand and/or prime any horizontal striations due to the printing process.
  4. Remove supports starting from the tip down and start by freeing those supports connected to small and fragile details.
  5. Recommend using CA for attaching item to model or filling any imperfections.
  6. Item(s) will have features that are brittle or extremely delicate and prone to breaking if not properly handled.
  7. 3D print support configurations may be different than the ones in the photos if applicable.
  8. Photos may include the CAD rendered file used for printing to highlight details that do not stand out well in regular photos.
  9. Not intended for small children due to choking hazard and should only be purchased by experienced modelers due fine details and printer support removal.
  10. The number of items in your order is calculated by multiplying the quantity you selected by the number of items per set if applicable.
  11. The small holes on the print are necessary to drain the hollow parts of the item of leftover resin.  Fill hole with CA and sand. 

The 100 pound frag bomb cluster AN-M1A2 consists of six 20 pound frag bombs AN-M41A1 assembled in cluster adapter AN-M1A3. The cluster adapter AN-M1A3 is a “quick-opening frame,” a mechanical type of adapter which holds the bombs in two banks of three bombs each and releases them upon withdrawal of the arming wires. The bomb cluster is issued with individual bombs assembled but unfuzed; fuzing is performed before the cluster is installed in the aircraft. Cluster adapter AN-M1A3 has four sheet-metal bomb supports spaced at intervals on two tubes. Three flat steel suspension lugs and two side plates are attached to the upper tube. Two spring strips are fitted to the bottom tube. Fuze-vane lock springs fit into a ferrule in front of the spring strips. Three lock springs pass through the front support and three through the third support. The fuze-vane lock springs prevent rotation of the fuze arming vanes while the bombs are in the cluster. Two metal straps hold the bombs in place against the adapter; their free ends are locked in place by a toggle strap clamp secured by the arming wire.

The difference between frag bomb clusters AN-M1A1 and AN-M1A2 lies in the cluster adapters. The AN-M1A1 uses the cluster adapters M1A2 or M1A1 (instead of the M1A3) which has narrow U-type suspension lugs; with these lugs, the complete weight of the cluster is only 125 pounds.  US Cluster, 100 lb Frag, AN-M1A1, AN-M1A2, M1 (bulletpicker.com)